* This is the Professional Version. *
Sperm disorders include defects in quality or quantity of sperm produced and defects in sperm emission. Diagnosis is by semen and genetic testing. The most effective treatment is usually in vitro fertilization via intracytoplasmic sperm injection.
Spermatogenesis occurs continuously. Each germ cell requires about 72 to 74 days to mature fully. Spermatogenesis is most efficient at 34° C. Within the seminiferous tubules, Sertoli cells regulate maturation, and Leydig cells produce the necessary testosterone . Fructose is normally produced in the seminal vesicles and secreted through the ejaculatory ducts.
Sperm disorders may result in an inadequate quantity of sperm—too few (oligospermia) or none (azoospermia)—or defects in sperm quality, such as abnormal motility or structure.
Spermatogenesis can be impaired (see Table: Causes of Impaired Spermatogenesis) by the following, resulting in an inadequate quantity or defective quality of sperm:
Causes of Impaired Spermatogenesis
Sperm emission may be impaired because of
Retrograde ejaculation is often due to
Sperm emission can also be impaired by
Almost all men with symptomatic cystic fibrosis have congenital bilateral absence of the vas deferens.
When couples are infertile, the man should always be evaluated for sperm disorders. History and physical examination focus on potential causes (eg, GU disorders). Volume of each testis should be determined; normal is 20 to 25 mL. Semen analysis should be done.
If oligospermia or azoospermia is detected, genetic testing should be done. These tests include
Before a man with a CFTR gene mutation and his partner attempt to conceive, the partner should also be tested to exclude cystic fibrosis carrier status.
Before semen analysis, the man is typically asked to refrain from ejaculation for 2 to 3 days. However, data indicate that daily ejaculation does not reduce the sperm count in men unless there is a problem. Because sperm count varies, testing requires ≥ 2 specimens obtained ≥ 1 wk apart; each specimen is obtained by masturbation into a glass jar, preferably at the laboratory site. If this method is difficult, the man can use a condom at home; the condom must be free of lubricants and chemicals. After being at room temperature for 20 to 30 min, the ejaculate is evaluated (see Table: Semen Analysis).
Additional computer-assisted measures of sperm motility (eg, linear sperm velocity) are available; however, their correlation with fertility is unclear.
If a man without hypogonadism or congenital bilateral absence of the vas deferens has an ejaculate volume < 1 mL, urine is analyzed for sperm after ejaculation. A disproportionately large number of sperm in urine vs semen suggests retrograde ejaculation.
Endocrine evaluation is warranted if the semen analysis is abnormal and especially if the sperm concentration is < 10 million/mL. Minimum initial testing should include serum follicle-stimulating hormone (FSH) and testosterone levels. If testosterone is low, serum luteinizing hormone (LH) and prolactin should also be measured. Men with abnormal spermatogenesis often have normal FSH levels, but any increase in FSH is a clear indication of abnormal spermatogenesis. Elevations in prolactin require evaluation for a tumor involving or impinging on the anterior pituitary or may indicate ingestion of various prescription or recreational drugs.
Specialized sperm tests, available at some infertility centers, may be considered if routine tests of both partners do not explain infertility and in vitro fertilization or gamete intrafallopian tube transfer is being contemplated. They include the following:
The usefulness of these specialized tests is controversial and unproved.
If necessary, testicular biopsy can distinguish between obstructive and nonobstructive azoospermia.
Underlying GU disorders are treated.
For men with sperm counts of 10 to 20 million/mL and no endocrine disorder, clomiphene citrate (25 to 50 mg po once/day taken 25 days/mo for 3 to 4 mo) can be tried. Clomiphene, an antiestrogen, may stimulate sperm production and increase sperm counts. However, whether it improves sperm motility or morphology is unclear, and it has not been proved to increase fertility.
If sperm count is < 10 million/mL or clomiphene is unsuccessful in men with normal sperm motility, the most effective treatment is usually in vitro fertilization with injection of a single sperm into a single egg ( intracytoplasmic sperm injection). Alternatively, intrauterine insemination using washed semen samples and timed to coincide with ovulation is sometimes tried. If pregnancy is going to occur, it usually occurs by the 6th treatment cycle.
Decreased number and viability of sperm may not preclude pregnancy. In such cases, fertility may be enhanced by controlled ovarian hyperstimulation of the woman plus artificial insemination or assisted reproductive techniques (eg, in vitro fertilization, intracytoplasmic sperm injection).
If the male partner cannot produce enough fertile sperm, a couple may consider insemination using donor sperm. Risk of AIDS and other sexually transmitted diseases is minimized by freezing donor sperm for ≥ 6 mo, after which donors are retested for infection before insemination proceeds.
Drug NameSelect Brand Names
cyproteroneNo US brand name
NitrofurantoinFURADANTIN, MACROBID, MACRODANTIN
* This is the Professional Version. *